Macrom M2A.490 Manual de usuario

Owner’s ManualM2A.490www.macrom.ch

09Power connection(Eng) Connect the Positive (+12V) directly to the Battery of the car. To make sure itself to insert a fuse of adequate amperage in o

FeaturesRMS Power at 4 ohm Stereo load at 14,4 volts 60 x 4 wattsRMS Power at 2 ohm Stereo load at 14,4 volts 90 x 4 watts RMS Power at 4 ohm Bridg

Front/Rear viewLow Level Input (CH1/CH2)High Level Input (CH1/CH2 & CH3/CH4)Gain Control (CH1/CH2)High pass switch (CH1/CH2)High pass cutting adj

02Input setting CH1/CH2Low Level Input (Eng) Connect the output Audio coming from the car radio, in to the Low level input of the amplifi er.(FR) Relie

03Input setting CH3/CH4Low Level Input (Eng) Connect the output Audio coming from the car radio, in to the Low level input of the amplifi er.(FR) Relie

04Crossover setting CH1/CH2(Eng) The cut frequency is selectable between 30 to 600 Hz. (FR) La fréquence de coupe est sélectionnable entre 30 à 600

05Crossover setting CH3/CH4(Eng) The cut frequency is selectable between 30 to 600 Hz. (FR) La fréquence de coupe est sélectionnable entre 30 à 600

06Input/Output Mode setting

07(Eng) Minimal acceptable Impedance 2 ohm. To adhere itself to the illustrations for the connections. (FR) Impédance acceptable minimale 2 ohms. P

08(Eng) Minimal acceptable Impedance 2 ohm. To adhere itself to the illustrations for the connections. (FR) Impédance acceptable minimale 2 ohms. P